Brewer Element Treatment 2210 Bedienungsanleitung

Document 101293 RevAPrinted in USA © 20101Document 101293 RevAPrinted in USA © 2010Overview ...

Document 101293 RevAPrinted in USA © 201010MODEL 2210 STEP 8To install drawers, pull drawer slides forward and align the slots of the drawer-mounted s

Document 101293 RevAPrinted in USA © 201011Leveling the Table A Leveling Screw Pad is located at each corner under thetable’s base. Adjust the four Le

Document 101293 RevAPrinted in USA © 201012Preventative Maintenance• Inspect the mechanical functions to ensure satisfac-tory operation.• Check fasten

Document 101293 RevAPrinted in USA © 201021/4”-20 x 3” Screw A (Qty. 2)1/4”-20 x 1 1/4” Screw C (Qty. 8)1/4”-20 x 1” Screw F (Qty. 4)J-Bolt R (Qty.

Document 101293 RevAPrinted in USA © 20103NotchMODEL 2210 STEP 1STEP A: Start with table frame inverted: note the position of the Notch in the drawin

Document 101293 RevAPrinted in USA © 20104MODEL 2210 STEP 2Foot EndScrew BScrew BScrew BScrew BScrew BSTEP A: With table in the upright position insta

Document 101293 RevAPrinted in USA © 20105MODEL 2210 STEP 3STEP A: Remove one Drawer Support screw from the Head End of the table as shown. STEP B: In

Document 101293 RevAPrinted in USA © 20106MODEL 2210 STEP 4STEP A: Install Screw G (1/4”-20 x 1/2”) through Tab and Paper Shelf as shown. Tighten Nut

Document 101293 RevAPrinted in USA © 20107MODEL 2210 STEP 5STEP A: The drawers can be installed so they open from the right hand side (RH Side) or the

Document 101293 RevAPrinted in USA © 20108MODEL 2210 STEP 6Install J-Bolts ontoupholstery topJ-Bolt RSTEP B: Set upholstery top and bottom on frame, w

Document 101293 RevAPrinted in USA © 20109MODEL 2210 STEP 7Snap Rivet Snap Rivet STEP A: Loosen Screws B at the foot of the table where indicated jus